Wormhole Community Scouting Guide: Difference between revisions

Line 56:

#If the POS is completely gone, delete it from the mapper by clicking the little circle with a slash icon next to the POS in the "Starbases" tab - ''see image 1 on right''

#If the POS is still there but only anchored, change that designation by clicking the little pencil icon next to the POS in the "Starbases" tab - ''see image 1 on right''

#Do a d-scan at ~~the lowest distance notch (~~1~~,000,000km)~~ and at 360 degrees before you warp off to see if there are any other active POSes at your current planet - especially if the mapper shows that there ''should'' be a POS at your location but you don't see one. Often the corp will move their POS to another moon at the same planet. If this is the case, you'll learn how to add a new POS to the mapper below

#Do a d-scan at 1 AU and 360 degrees before you warp off to see if there are any other active POSes at your current planet - especially if the mapper shows that there ''should'' be a POS at your location but you don't see one. Often the corp will move their POS to another moon at the same planet. If this is the case, you'll learn how to add a new POS to the mapper below

#Once you have done the above for each listed active POS, you are ready to check the rest of the system for any new inhabitants

#Keep d-scanning as you perform the above steps!

@@ Line 56: / Line 56: @@
 #If the POS is completely gone, delete it from the mapper by clicking the little circle with a slash icon next to the POS in the "Starbases" tab - ''see image 1 on right''
 #If the POS is still there but only anchored, change that designation by clicking the little pencil icon next to the POS in the "Starbases" tab - ''see image 1 on right''
-#Do a d-scan at the lowest distance notch (1,000,000km) and at 360 degrees before you warp off to see if there are any other active POSes at your current planet - especially if the mapper shows that there ''should'' be a POS at your location but you don't see one. Often the corp will move their POS to another moon at the same planet. If this is the case, you'll learn how to add a new POS to the mapper below
+#Do a d-scan at 1 AU and 360 degrees before you warp off to see if there are any other active POSes at your current planet - especially if the mapper shows that there ''should'' be a POS at your location but you don't see one. Often the corp will move their POS to another moon at the same planet. If this is the case, you'll learn how to add a new POS to the mapper below
 #Once you have done the above for each listed active POS, you are ready to check the rest of the system for any new inhabitants
 #Keep d-scanning as you perform the above steps!