Toggle menu
Toggle preferences menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

Gallente Basic Ship and Skill Overview: Difference between revisions

From EVE University Wiki
Line 890: Line 890:
* This fitting should have approximately 100k EHP and 475 DPS with recommended skills. The light neutrons have a very short optimal, and the scram + double webs can help keep enemies in place to apply full DPS.
* This fitting should have approximately 100k EHP and 475 DPS with recommended skills. The light neutrons have a very short optimal, and the scram + double webs can help keep enemies in place to apply full DPS.


* The high slots can be changed to suit the needs of the fleet. Drone Link Augmentor, Remote Armor Repair, Cap Transfer Array, and Energy Neutralizer are all good options to fit. If these modules take up too much pg, one of the 1600mm plates can be switched out to an Energized Reactive Membrane II. The plate could also be switched to a Reactior Control Unit or Co-Processor, however these should not be used as substitutes for poor fitting skills (Engineering V and Electronics V at least, as well as Weapon Upgrades and perhaps Advanced Weapon Upgrages). This fit needs at least one 1600mm plate to have adequate EHP, and preferrably EHP over 75k.
* The high slots can be changed to suit the needs of the fleet. Drone Link Augmentor, Remote Armor Repair, Cap Transfer Array, and Energy Neutralizer are all good options to fit. If these modules take up too much pg, one of the 1600mm plates can be switched out to an Energized Reactive Membrane II. The plate could also be switched to a Reactior Control Unit or Co-Processor, however these should not be used as substitutes for poor fitting skills (Engineering V and Electronics V at least, as well as Weapon Upgrades and perhaps Advanced Weapon Upgrages). This fit needs at least one 1600mm plate to have adequate EHP, and preferrably EHP over 75k. If cap-intensive high slot modules are used, one of the webs should be switched to a Medium Capacitor Booster II with 800 charges.


* Rolled Tungsten plates are nearly always preferred over Tech 2 plates because of the lower fitting requirements and the lower mass increase.
* Rolled Tungsten plates are nearly always preferred over Tech 2 plates because of the lower fitting requirements and the lower mass increase.