Toggle menu
Toggle preferences menu
Toggle personal menu
Not logged in
Your IP address will be publicly visible if you make any edits.

Odyssey: Difference between revisions

From EVE University Wiki
Neville smit (talk | contribs)
Neville smit (talk | contribs)
Line 17: Line 17:
The Discovery Scanner is basically a new visualisation of the former on-board scanner, with a few additions. Every time you enter a system the Discovery Scanner will start to search for cosmic anomalies and signatures. You will see a scan sweep moving from one side of your screen to the other and further all around the system.
The Discovery Scanner is basically a new visualisation of the former on-board scanner, with a few additions. Every time you enter a system the Discovery Scanner will start to search for cosmic anomalies and signatures. You will see a scan sweep moving from one side of your screen to the other and further all around the system.


[img]http://neural-boost.com/images/eve_odyssey/scansweep.jpg[/img]
[[Media:http://neural-boost.com/images/eve_odyssey/scansweep.jpg]]


Along with this, if the system has any anomalies or signatures, you will notice icons poping up in space, similar to the brackets of stations or stargates. These icons will not only mark the position of exploration sites, but also indicate your progress of pinpointing them. Anomalies will allways be at 100% signal strength right from the initial scan sweep, just like they do now. Signature results will only tell you the very rough area where they are located but will have 0% signal strength at the start, requiring you to further probe scan them down (see the next section). You can also interact with those icons via a tooltip window that will pop up when you hover over them.
Along with this, if the system has any anomalies or signatures, you will notice icons poping up in space, similar to the brackets of stations or stargates. These icons will not only mark the position of exploration sites, but also indicate your progress of pinpointing them. Anomalies will allways be at 100% signal strength right from the initial scan sweep, just like they do now. Signature results will only tell you the very rough area where they are located but will have 0% signal strength at the start, requiring you to further probe scan them down (see the next section). You can also interact with those icons via a tooltip window that will pop up when you hover over them.