Orca: Difference between revisions

Line 135:

== Tactics ==

Miners in the fleet can have direct access only to the fleet hangar bay. The Orca pilot must move ore from the fleet hangar bay to the ~~ore~~ hold or the cargo bay when the fleet hangar gets too full. Typically, it’s good practice to place mining crystals, both T1 and T2s in the fleet hangar, so the fleet can have access to new ones when theirs burn out. This takes up just a little of the fleet hangar.

Miners in the fleet can have direct access only to the fleet hangar bay. The Orca pilot must move ore from the fleet hangar bay to the mining hold or the cargo bay when the fleet hangar gets too full. Typically, it’s good practice to place mining crystals, both T1 and T2s in the fleet hangar, so the fleet can have access to new ones when theirs burn out. This takes up just a little of the fleet hangar.

The mining fleet can use the Orca's ship maintenance bay to reconfigure their mining ship, swapping out fittings for different purposes. To enable this, the Orca pilot must configure the Orca to allow this access. This is done by the Orca pilot right clicking on the Orca, clicking on the Configure Ship menu item, and clicking the “Allow Fleet Member Usage” box.

@@ Line 135: / Line 135: @@
 == Tactics ==
 {{See also|Orca Guide}}
-Miners in the fleet can have direct access only to the fleet hangar bay. The Orca pilot must move ore from the fleet hangar bay to the ore hold or the cargo bay when the fleet hangar gets too full. Typically, it’s good practice to place mining crystals, both T1 and T2s in the fleet hangar, so the fleet can have access to new ones when theirs burn out. This takes up just a little of the fleet hangar.
+Miners in the fleet can have direct access only to the fleet hangar bay. The Orca pilot must move ore from the fleet hangar bay to the mining hold or the cargo bay when the fleet hangar gets too full. Typically, it’s good practice to place mining crystals, both T1 and T2s in the fleet hangar, so the fleet can have access to new ones when theirs burn out. This takes up just a little of the fleet hangar.
 The mining fleet can use the Orca's ship maintenance bay to reconfigure their mining ship, swapping out fittings for different purposes. To enable this, the Orca pilot must configure the Orca to allow this access. This is done by the Orca pilot right clicking on the Orca, clicking on the Configure Ship menu item, and clicking the “Allow Fleet Member Usage” box.